Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT SEAT SIDE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
* The nuts must not be reused.
* Make sure that the front seatback frame sub-assembly or separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat airbag assembly with 2 new nuts.

for TMMK Made - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

for SIA Made - Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Engage the 2 clamps.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for TMMK Made Manual Seat) Reassembly

3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for SIA Made Manual Seat) Reassembly

4. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for TMMK Made Power Seat) Reassembly

5. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for SIA Made Power Seat) Reassembly

6. CONNECT AIRBAG WIRE HARNESS (for TMMK Made Manual Seat)

(a) Engage the claw and 3 clamps to connect the airbag wire harness.

(b) Connect the 2 rubber bands of the separate type front seatback cover with pad.

7. CONNECT AIRBAG WIRE HARNESS (for SIA Made Manual Seat)

(a) Engage the claw and 3 clamps to connect the airbag wire harness.

(b) Engage the fastener to connect the airbag wire harness.

(c) Connect the rubber band of the separate type front seatback cover with pad.

8. CONNECT AIRBAG WIRE HARNESS (for TMMK Made Power Seat)

(a) w/ Seat Heater System:

(1) Connect the connector (E).





(2) Engage the clamp (F).

(b) Engage the claw (D) and 3 clamps (C) to Connect the airbag wire harness.

(c) Engage the clamp (B).

(d) Connect the connector (A).

(e) Connect the 2 rubber bands of the separate type front seatback cover with pad.

9. CONNECT AIRBAG WIRE HARNESS (for SIA Made Power Seat)

(a) w/ Seat Heater System:

(1) Connect the connector.

(2) Engage the clamp.

(b) Engage the claw and 3 clamps to Connect the airbag wire harness.

(c) Engage the fastener to connect the airbag wire harness.

(d) Connect the rubber band of the separate type front seatback cover with pad.

10. INSTALL FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat)

Installation

11. INSTALL FRONT SEAT ASSEMBLY (for SIA Made Manual Seat)

Installation

12. INSTALL FRONT SEAT ASSEMBLY (for TMMK Made Power Seat)

Installation

13. INSTALL FRONT SEAT ASSEMBLY (for SIA Made Power Seat)

Installation

14. PERFORM DIAGNOSTIC SYSTEM CHECK

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor