Knock Sensor Replacement (Right)

Knock Sensor Replacement (Right)

Removal Procedure




1. Remove the right exhaust manifold.
2. Remove the right catalytic convertor.

Important: In the following service procedure, it maybe necessary to remove the starter assembly to gain enough clearance to remove the knock sensor.

3. Remove the starter assembly (4), ONLY IF NEEDED.
4. Remove the knock sensor mounting (1).
5. Remove the knock sensor (2) from the engine block (5).
6. Disconnect the engine electrical connector (3) from the knock sensor (2).
7. Remove the knock sensor (2).

Installation Procedure




1. Reconnect electrical connector (3) for the engine harness to the knock sensor (2).
2. Position the knock sensor (2) on the engine block (5).
3. Install the mounting bolt (1) for the knock sensor (2).

Notice: Refer to Fastener Notice.

4. Tighten the knock sensor mounting bolt (1).

Tighten the knock sensor mounting bolt 1 to 20 N.m (15 lb ft).

5. Install the starter assembly (4), ONLY IF REMOVED.
6. Install the right catalytic convertor.
7. Install the right exhaust manifold.

Important: Perform the following procedure only if the battery has been disconnected.

8. Program the transmitters. Refer to Transmitter Programming (Domestic and Japan) Transmitter Programming (Export - Including Canada). Programming and Relearning