Lower Control Arm Replacement

Lower Control Arm Replacement (RWD)

Tools Required
* J 43631 Ball Joint Remover
* J 45851 Ball Joint Separator Protector Adapters

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel.
3. Remove the front coil spring.
4. Remove the lower ball joint retaining nut.




5. Disconnect the lower ball joint from the steering knuckle using J 43631 and J 45851 .
6. Remove the lower control arm.

Installation Procedure




1. Install the lower control arm.
2. Connect the lower ball joint to the steering knuckle.

Notice: Refer to Fastener Notice .

3. Install the lower ball joint retaining nut.

Tighten the nut to 100 N.m (74 lb ft).

4. Install the front coil spring.
5. Install the tire and wheel.
6. Lower the vehicle.
7. Check the wheel alignment. Refer to Measuring Wheel Alignment .