Windshield Washer Pump: Service and Repair

REMOVAL
1. Partially remove the bumper facia as needed to gain access to the reservoir pump.
2. Place a drain bucket below the reservoir to catch any washer solvent that may leak out.

Washer Pump:

3. Firmly grasping pump by hand twist and pull-away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
4. Remover rubber grommet from reservoir and throw away.

INSTALLATION
- For installation, reverse the above procedures. A new grommet is required for installation. Refill reservoir with the washer solvent.