Ignition Control Module: Testing and Inspection

NOTE: An analog-type ohmmeter should be used.

Ignition Power Transistor:

Ignition Power Transistor Continuity Check:

No. 1 - No. 4 Coil Side
1. Connect the negative (-) terminal of the 1.5 V power supply to terminal 3 of the ignition power transistor; then check whether there is continuity between terminal 8 and terminal 3 when terminal 7 and the positive (+) terminal are connected and disconnected.

NOTE: Connect the (-) probe of the ohmmeter to terminal 8.

2. Replace the ignition power transistor if there is a malfunction.

Ignition Power Transistor:

Ignition Power Transistor Continuity Check:

No. 2 - No. 3 Coil Side
1. Connect the negative (-) terminal of the 1.5 V power supply to terminal 3 of the ignition power transistor; then check whether there is continuity between terminal 1 and terminal 3 when terminal 2 and the positive (+) terminal are connected and disconnected.

NOTE: Connect the (-) probe of the ohmmeter to terminal 1.

2. Replace the ignition power transistor if there is a malfunction.