Engine Oil Pressure Sensor/Switch

REMOVAL PROCEDURE

SPECIAL TOOLS
J 41712 Oil Pressure Sensor/Switch Socket

1. Remove the Engine Cover.
2. Remove the upper intake manifold
3. Remove the harness connector from the oil pressure switch by releasing the locking tab.
4. Remove the switch (1), using the J41712 oil pressure sensor/switch socket.

INSTALLATION PROCEDURE
1. Install the switch (1), using the J41712 oil pressure sensor/switch socket.
2. Install the harness connector
3. Install the upper intake manifold.

IMPORTANT: Ensure that the PCM electrical harness is properly routed to avoid contact with the Engine Cover during installation.

4. Install the Engine Cover.