Fluid Replacement

^ Tools Required
- J36511 Oil Fill/Drain Plug Hex Bit (17 MM)


Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.





2. Using J36511, remove the oil fill and drain plugs. Catch the oil in a suitable container.

Installation Procedure





1. Apply sealant to the oil drain plug threads. Use sealant GM P/N 12346004 or the equivalent.

Notice: Refer to Fastener Notice in Service Precautions.

2. Using J36511, install the oil drain plug.
^ Tighten the oil drain plug to 60 Nm (44 ft. lbs.).





3. Fill the transmission to the level of the fill plug hole. Refer to Lubrication Specifications.
4. Apply sealant to the oil fill plug threads. Use sealant GM P/N 12346004 or the equivalent.
5. Using J36511, install the oil fill plug.
^ Tighten the oil fill plug to 60 Nm (44 ft. lbs.).
6. Lower the vehicle.