61. Camshaft Cover Installation

Camshaft Cover Installation (LAF)




1. Install NEW camshaft cover grommets and camshaft cover bolts if they are serviced with the grommet.
2. Assemble the camshaft cover (1) and a NEW gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the cover on the cylinder head and hand start the bolts. Tighten the bolts to 10 Nm (89 lb in).




4. Install the camshaft housing cover insulator (1). Tighten the bolts to 10 Nm (89 lb in).




5. Install the ignition coil (1). Tighten the bolt to 10 Nm (89 lb in).




6. Install the front lift bracket (1).
7. Install the front lift bracket bolts and tighten to 25 Nm (18 lb ft).




8. Install the rear lift bracket (1).
9. Install the rear lift bracket bolts and tighten to 25 Nm (18 lb ft).