73. Cylinder Head Installation

Cylinder Head Installation

Tools Required
^ J45059 Angle Meter





1. Install the dowel pins - cylinder head locator, if necessary.
2. Install a new cylinder head gasket.





3. Install the cylinder head.





4. Install new cylinder head bolts.





Notice: Refer to Fastener Notice in Service Precautions.

5. Tighten the new cylinder head bolts in the following sequence:
1. Tighten the (12) long cylinder head bolts in sequence to 30 Nm (22 ft. lbs.).
2. se J45059 to tighten the cylinder head bolts in sequence an additional 155 degrees.
3. Tighten the (2 Short) end bolts to 7 Nm (62 inch lbs.). Use J45059 to tighten the short cylinder head end bolts an additional 60 degrees.
4. Tighten the (1 Long) end bolt to 7 Nm (62 inch lbs.). Use J45059 to tighten the long cylinder head end bolt an additional 120 degrees.