Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 1993 >> RX7 2RTR-1308cc 80 >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Exhaust Temperature Sensor >> Testing and Inspection
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Exhaust Temperature Sensor: Testing and Inspection

WARNING SYSTEM INSPECTION
1. Turn ignition switch "ON." Verify that heat hazard warning lamp illuminates.
2. Start engine and verify that lamp goes out.

Warning System Check:





3. Disconnect sensor connector.
4. Jumper connector terminals (harness side) and verify that warning lamp is lit.
5. If not as specified, check lamp in dash, sensor, connections and wiring harness.

Heat Hazard Sensor Testing:





SENSOR INSPECTION
1. Remove sensor from vehicle.
2. Wrap sensor and a thermometer in aluminum foil and place in a container of oil.
3. Connect a test lamp and 12V power source to sensor connector terminals.
4. Gradually heat oil and verify that test lamp illuminates when temperature inside the foil reaches 221° - 239°F (105° - 115°C).

CAUTION: Do not heat oil above 302°F (150°C).

5. Replace sensor if it does not operate as specified.

pro multis · About Operation CHARM