INTERMEDIATE SHAFT SPEED (ISS) SENSOR INSPECTION [5R55S]

id0513c1253400

Caution

•  Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.

1.  Disconnect the negative battery cable.

2.  Remove the oxidation catalytic converter. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [WL-C, WE-C].)

3.  Remove the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION [5AT].)

4.  Remove the crossmember and transmission mount rubber. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [5R55S].)

5.  Lower the transmission slightly.

6.  Disconnect the ISS sensor connector.

absggw00001187

Caution

•  Do not apply a shock in the ISS sensor.

•  Do not damage the terminals.

7.  Measure the resistance between the ISS sensor terminals.

absggw00001189

•  If there is any malfunction, replace the ISS sensor. (See INTERMEDIATE SHAFT SPEED (ISS) SENSOR REMOVAL/INSTALLATION [5R55S].)

8.  Connect the ISS sensor connector.

9.  Install the crossmember and transmission mount rubber. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [5R55S].)

10.  Install the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION [5AT].)

11.  Install the oxidation catalytic converter (See EXHAUST SYSTEM REMOVAL/INSTALLATION [WL-C, WE-C].)

12.  Connect the negative battery cable.