1. DTC P0958 description
When the selector lever is operated from the D position to the right side, the TCM detects that the D position switch of the inhibitor switch and the manual select switch of the manual mode switch are closed, thus the mode switches to the manual mode. If the TCM detects that the inhibitor switch and the manual mode signal do not match, the DTC is set.
2. Condition for setting DTC P0958
Condition for running the DTC
- The ignition switch is ON.
- The battery voltage is 9.0 to 16.0 V.
- The ignition voltage is 9.0 to 16.0 V.
- The engine speed is 550 rpm or more.
- DTCs P0707, P0708, P2534, P2535, U0073, and U0100 are not set.
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC P0707 (Flash Code 17) Transmission Range Switch Circuit Low".
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC P0708 (Flash Code 17) Transmission Range Switch Circuit High".
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC P2534 (Flash Code 73) Ignition Switch Run/Start Position Circuit Low".
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC P2535 (Flash Code 73) Ignition Switch Run/Start Position Circuit High".
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC U0073 (Flash Code 65) Control Module Communication Bus Off".
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC U0100 (Flash Code 67) Lost Communication With ECM".
Condition for setting the DTC
- While the P, R, or N position switch is ON, the TCM detects that the manual select switch is ON for 2 seconds or more.
3. Action taken when DTC P0958 sets
- The TCM flashes the check trans warning light. Refer to Action taken when DTC sets - Type C.
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC type definitions".
- The TCM inhibits the manual mode.
4. Condition for clearing DTC P0958
- Refer to Condition for clearing the check trans warning light/DTC - Type C.
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC type definitions".