Note
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) diagnostic system check-transmission controls".
1) Connect the scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Start and warm up the engine.
4) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to Charging system inspection.
No
Go to Intermittent conditions of automatic transmission.
Refer to "206.Transmission, Transaxle 19D.Symptom(AWR6B45) Intermittent conditions of automatic transmission".
1) Inspect the charging system. Is the result normal?
Refer to "1.Engine 1J.Electrical(4JJ3 with DPD) generator inspection".
Refer to "202.Engine 15C.Functional Inspection(4JJ3 with DPD) charging system check".
Refer to "1.Engine 1J.Electrical(4JJ3 without DPD) generator inspection".
Refer to "202.Engine 15C.Functional Inspection(4JJ3 without DPD) charging system check".
Refer to "1.Engine 1J.Electrical(RZ4E-TC) generator inspection".
Refer to "202.Engine 15C.Functional Inspection(RZ4E-TC) charging system check".
Yes
No
Repair as necessary.
1) Clear the DTC with a scan tool.
Note
2) Turn OFF the ignition switch for 30 seconds or more.
3) Start and warm up the engine.
4) Observe the Ignition Voltage parameter on the scan tool. Is the Ignition Voltage parameter more than or equal to the specified value?
Value: 16 V
Yes
=>Go to Charging system inspection.
No
Observe the DTC information with a scan tool.