DTC B1E0E[54] Electronic Key Not Programmed (Wireless Access Module (Hi-version [Passive Entry and Start System]))

1. Wireless access module system check

Refer to "71.Security and Locks Control 10S.Troubleshooting(Wireless Access Module (Hi-version [Passive Entry and Start System])) Diagnostic system check-Wireless Access Module (Hi-version[Passive Entry and Start System])".

2. Electronic key ID programming

1) Perform programming of the electronic key ID in the wireless access module.

Refer to "9.Body, Cab, Accessories 9J.Security and Locks Electronic key setting".

Procedure completion

=>Go to Current DTC check.

3. Current DTC check

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch.

3) Press the engine start/stop button.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Wireless access module replacement.

No

=>Go to Repair verification.

4. Wireless access module replacement

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control wireless access module removal".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control wireless access module installation".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control wireless access module setting (with passive entry and start system)".

Procedure completion

=>Go to Repair verification.

5. Repair verification

1) Turn OFF the ignition switch.

2) Press the engine start/stop button.

3) Observe the DTC information with a scan tool.