DTC U0064[88] CAN Communication Malfunction (CAN Bus Off) (Wireless Access Module (Mid-version/Lo-version [Except Passive Entry and Start System]))

1. Current DTC check

1) Turn OFF the ignition switch.

2) Turn ON the ignition switch.

3) Observe the DTC information with a scan tool. Is a DTC set?

Yes (Models with radar sensors/stereo cameras)

Go to Body CAN communication circuit inspection.

Refer to "64.Body Control 10I.Troubleshooting(Central GateWay) body CAN communication circuit inspection".

=>Go to Repair verification.

Yes (Models without radar sensors and stereo cameras)

=>Go to CAN communication system inspection.

No

Go to Intermittent conditions of wireless access module.

Refer to "229.Security and Locks Control 42D.Symptom intermittent conditions of wireless access module".

2. CAN communication system inspection

1) Inspect the CAN communication system.

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 with DPD) scan tool does not communicate with CAN device (models without radar sensor and stereo camera)".

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) scan tool does not communicate with CAN device (models without radar sensor and stereo camera)".

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) scan tool does not communicate with CAN device (models without radar sensor and stereo camera)".

Procedure completion

=>Go to Repair verification.

3. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool.