DTC U0064[88] CAN Network: Bus-Off (CAN) (Auto A/C)

1. Current DTC check

1) Turn OFF the ignition switch.

2) Turn ON the ignition switch.

3) Observe the DTC information with a scan tool. Is a DTC set?

Yes (Models with radar sensors)

Go to Body CAN communication circuit inspection.

Refer to "64.Body Control 10I.Troubleshooting(Central GateWay) body CAN communication circuit inspection".

Yes (Models without radar sensors)

=>Go to CAN communication system inspection.

No

Go to Intermittent conditions of auto A/C control system.

Refer to "208.HVAC 21D.Symptom intermittent conditions of auto A/C control system".

2. CAN communication system inspection

1) Inspect the CAN communication system.

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 with DPD) scan tool does not communicate with CAN device (models without radar sensor and stereo camera)".

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) scan tool does not communicate with CAN device (models without radar sensor and stereo camera)".

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) scan tool does not communicate with CAN device (models without radar sensor and stereo camera)".

Procedure completion

=>Go to Repair verification.

3. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool.