DTC U2301 (Flash Code 181) Immobilizer Transponder Authentication NG (RZ4E-TC)

1. Engine control system check

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) Diagnostic system check-engine controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Immobilizer-related DTC check.

No

Go to Diagnostic system check-wireless access module.

Refer to "71.Security and Locks Control 10S.Troubleshooting(Wireless Access Module (Mid-version/Lo-version [Except Passive Entry and Start System])) Diagnostic system check-Wireless Access Module (Mid-version/Lo-version [Except Passive Entry and Start System])".

Refer to "71.Security and Locks Control 10S.Troubleshooting(Wireless Access Module (Hi-version [Passive Entry and Start System])) Diagnostic system check-Wireless Access Module (Hi-version[Passive Entry and Start System])".

3. Immobilizer-related DTC check

1) Observe the immobilizer-related DTC with a scan tool. Is an immobilizer-related DTC that starts with B set?

Yes

Go to the applicable DTC diagnosis.

No

=>Go to Immobilizer function check.

4. Immobilizer function check

1) Reprogram the immobilizer function into the ECM.

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM setting".

Procedure completion

=>Go to Programming verification.

5. Programming verification

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to ECM replacement.

No

=>Go to Repair verification.

6. ECM replacement

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM installation".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM setting".

Procedure completion

=>Go to Repair verification.

7. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine.

4) Operate the vehicle under the conditions for running the DTC.

5) Observe the DTC information with a scan tool.