DTC B110E[11] RLS(Rain and Light Sensor) Circuit Short to Ground (BCM)

1. Body control system check

Refer to "64.Body Control 10I.Troubleshooting(BCM) diagnostic system check-body controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Rain and light sensor inspection.

No

Go to Intermittent conditions of body control system.

Refer to "223.Body Control 36D.Symptom(BCM) intermittent conditions of body control system".

3. Rain and light sensor inspection

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch.

3) Disconnect the rain and light sensor harness connector (L4).

Refer to "LHD Body Control" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 with DPD)" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 without DPD, RZ4E)" in the ETM (wiring diagram). (Open using the ETM viewer.).

4) Turn ON the ignition switch.

5) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Inspection for short to ground in rain and light sensor ignition power supply circuit.

No

Replace the rain and light sensor.

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control rain and light sensor removal".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control rain and light sensor installation".

=>Go to Repair verification.

4. Inspection for short to ground in rain and light sensor ignition power supply circuit

1) Disconnect the BCM harness connector (B19).

2) Inspect the ignition power supply circuit between the BCM (pin 4 of B19) and the rain and light sensor (pin 3 of L4) for a short to ground. Is the result normal?

Refer to "LHD Body Control" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 with DPD)" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 without DPD, RZ4E)" in the ETM (wiring diagram). (Open using the ETM viewer.).

Yes

=>Go to BCM replacement.

No

Repair the circuit as necessary.

=>Go to Repair verification.

5. BCM replacement

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control BCM removal".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control BCM installation".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control BCM setting".

Procedure completion

=>Go to Repair verification.

6. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool.