1) Check whether the shape of the radar sensor bracket is deformed or damaged. Is the result normal?
Yes
=>Go to Radar sensor bracket installation section shape check.
No
Replace the radar sensor bracket.
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. radar sensor removal".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. radar sensor installation".
1) Check whether the shape of the radar sensor bracket installation section is deformed or damaged. Is the result normal?
Yes
=>Go to Radar sensor (Right) installation position check.
No
Repair or replace the radar sensor bracket installation section as necessary.
1) Check the installation position of the radar sensor (Right).
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. radar sensor installation".
2) If the radar sensor (Right) installation position is improper, adjust the installation position.
Procedure completion
1) Connect the scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Start the engine and perform a test run.
4) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to Radar sensor (Right) replacement.
No
Note
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. radar sensor removal".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. radar sensor installation".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. radar sensor setting".
Procedure completion
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool.