UP SWITCH INSPECTION [FW6A-EL, FW6AX-EL]

id0517h2600500


Continuity Inspection

Note
•  The up switch is built into the selector lever component.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)
(2)  Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)
(3)  Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION.)
(4)  Cup holder (See CUP HOLDER REMOVAL/INSTALLATION.)
(5)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
(6)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
(7)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
(8)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

3.  Disconnect the selector lever component connector.

ac5uuw00005623

4.  Verify that the continuity between selector lever component terminals C and H.

adejjw00010856

•  If not as verified, replace the selector lever component. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

Up switch specification

Test condition

Continuity
Selector lever is in the M position (+) side position.
Continuity
Selector lever is not in the M position (+) side position.
No continuity