CENTER ACCESSORY SOCKET INSPECTION
id092100900900
1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)
2. Remove the following parts:
- (1) Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)
-
- (2) Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION.)
-
- (3) Cup holder (See CUP HOLDER REMOVAL/INSTALLATION.)
-
- (4) Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)
-
- (5) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
-
- (6) Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
-
- (7) Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
-
- (8) Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)
-
- (9) Center accessory socket (See CENTER ACCESSORY SOCKET REMOVAL/INSTALLATION.)
-
3. Connect the tester probe to the position shown in the figure and verify that there is continuity.
-
