No.5 DOOR GLASS STOPS BEFORE FULLY OPENING/CLOSING [POWER WINDOW SYSTEMS (EXTERIOR OPEN/CLOSE FUNCTION)]
id090361809000
5 |
DOOR GLASS STOPS BEFORE FULLY OPENING/CLOSING |
---|---|
POSSIBLE CAUSE
|
• Power window main switch malfunction
• Power window subswitch (passenger side) malfunction
• Power window motor malfunction
• Battery malfunction (low voltage)
• Door glass improper installation
• Power window initialization procedure error
• Keyless control module malfunction
• BCM malfunction
• Keyless entry system signal reception error (outside operation area, radio signal interference)
|
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
• Operate the door glass in auto/manual by operating the power window main switch/power window subswitch (passenger side).
• Does the door glass stop before fully opening/closing using either operation?
|
Yes
|
Inspect the following parts, and repair or replace.
• Power window main switch
• Power window subswitch (passenger side)
• Power window motor )
• Battery (low voltage)
• Door glass (Installation condition)
|
No
|
Go to the next step.
|
||
2
|
• Inspect the operation of the door glass by repeating Step 1 above.
• Does the door glass stop before fully opening/closing while in auto operation?
|
Yes
|
Perform the power window initialization procedure.
|
No
|
Go to the next step.
|
||
3
|
• Open the door glass by operating the transmitter.
• Does the door glass stop moving before it reaches the fully-opened position with the button on the transmitter held pressed?
|
Yes
|
Inspect the following parts, and repair or replace.
• Keyless control module (Vehicles with advanced keyless system)
• BCM (See BODY CONTROL MODULE (BCM) INSPECTION.)
|
No
|
Go to the next step.
|
||
4
|
• Close the door glass by operating the transmitter.
• Does the door glass stop moving before it reaches the fully-closed position with the button on the transmitter held pressed?
|
Yes
|
Inspect the following parts, and repair or replace.
• Keyless control module (Vehicle with advanced keyless system)
• BCM (See BODY CONTROL MODULE (BCM) INSPECTION.)
• Keyless entry system signal reception error (outside operation area, radio signal interference)
|
No
|
Reinspect for malfunction recurrence.If the malfunction is not corrected, repeat the procedure from Step 1.
|