PUSH BUTTON START INSPECTION

id091400006900

Resistance Inspection

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2. Remove the following parts:

(1) Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)

(2) Shift lever knob (MT)

(3) Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION.)

(4) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(5) Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION.)

(6) Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

(7) Front console panel (See FRONT CONSOLE PANEL REMOVAL/INSTALLATION.)

(8) Front console component (See FRONT CONSOLE REMOVAL/INSTALLATION.)

(9) Scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION.)

(10) Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(11) A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(12) Bonnet release lever (See BONNET RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)

(13) Driver-side lower panel (See DRIVER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

(14) Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

(15) Center panel No.1 (See CENTER PANEL No.1 REMOVAL/INSTALLATION.)

(16) Push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION.)

3. Verify that the continuity between the push button start terminals is as indicated in the table.

am3uuw00009904

am3uuw00009903

• If not as indicated in the table, replace the push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION.)

LED Illumination Inspection