OIL SEAL (DIFFERENTIAL) REPLACEMENT [F35M-R]
id0515a1800200
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Remove the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)
3. Drain the oil from the transaxle. (See TRANSAXLE OIL REPLACEMENT [F35M-R].)
4. Separate the drive shaft and joint shaft from the transaxle. (See DRIVE SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6, MZR 2.3 DISI Turbo, MZR 2.5].)
5. Remove the oil seals using a screwdriver.
am2zzw00000183
|
6. Using the SST and a hammer, tap each new oil seal in evenly until the SST contacts the transaxle case.
am2zzw00001659
|
7. Coat the lip of each oil seal with transaxle oil.
8. Insert the drive shaft and joint shaft to the transaxle. (See DRIVE SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6, MZR 2.3 DISI Turbo, MZR 2.5].)
9. Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT [F35M-R].)
10. Install the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)