SHIFT-LOCK SYSTEM INSPECTION

id051800297100


Shift-Lock System Inspection

1.  Switch the ignition to ON.

2.  Shift the selector lever to the P position.

3.  Perform the following procedures to inspect the shift-lock system.

•  If there is any malfunction, inspect the shift-lock solenoid and P position switch. (See Shift-Lock Solenoid and P Position Switch Inspection.)
(1)  Verify that the selector lever cannot be shifted from P to R position when the brake pedal is released.
(2)  Verify that the selector lever can be shifted from P to R position when the brake pedal is depressed.


Shift-Lock Solenoid and P Position Switch Inspection

1.  Perform the following procedures.

(1)  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
(2)  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
(3)  Remove the console. (See CONSOLE REMOVAL/INSTALLATION.)
(4)  Disconnect the selector lever component connector.

L.H.D.

am3uuw00002999

R.H.D.

am3zzw00005106

2.  Measure the voltage between the selector lever component terminals.

am3uuw00002437

•  If there is any malfunction, repair or replace the related wiring harness.
•  If there is no malfunction even though the shift-lock system has any malfunction, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

Shift-lock solenoid specification

Terminals

Connected to

Test condition

Voltage (V)
E—GND
Brake switch
Brake pedal released
Below 1.0
Brake pedal depressed
B+
I—GND
Ignition switch
Switch the ignition to off
Below 1.0
Switch the ignition to ACC or ON
B+
K—GND
GND
Under any condition
Below 1.0


Emergency Override Button Inspection

1.  Switch the ignition to off.

2.  Verify that the selector lever is in the P position.

3.  Without the brake pedal depressed, verify that the selector lever cannot be shifted from the P position.

4.  Remove the cover using a tape-wrapped flathead screwdriver.

L.H.D.

am3uuw00002303

R.H.D.

am3zzw00005067

5.  Insert the flathead screwdriver into the emergency override hole and push it down.

6.  Verify that the selector lever can be shifted from the P position.

•  If there is any malfunction, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)