DISCHARGE HEADLIGHT CONTROL MODULE REMOVAL/INSTALLATION

id091800805300

Caution

•  Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the discharge headlight service warnings. (See DISCHARGE HEADLIGHT SERVICE WARNINGS.)

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].) (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

2.  Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

3.  Remove the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)

4.  Remove the screws.

am3uuw00007846

5.  Disconnect the connector A.

6.  Remove the screw.

am3uuw00002715

7.  Disconnect the connector B.

8.  Remove the discharge headlight control module.

9.  Rotate the cover in the direction of the arrow shown in the figure to remove it.

am3uuw00004415

10.  Rotate the connector in the direction of the arrow shown in the figure to remove it.

am3uuw00002707

11.  Remove the short cord.

am3zzw00010326

12.  Install in the reverse order of removal.