AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION

id091800805500

Note

•  Perform the headlight auto leveling system initialization after newly replacing the auto leveling control module to assure that the auto leveling system operates correctly.

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].) (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

2.  Remove the following parts:

(1)  Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(4)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(5)  Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

3.  Remove in the order indicated in the table.

am3uuw00007852

1	Nut
2	Connector
3	Auto leveling control module

4.  Install in the reverse order of removal.

5.  Perform the headlight auto leveling system initialization after newly replacing the auto leveling control module. (See HEADLIGHT AUTO LEVELING SYSTEM INITIALIZATION.)