DTC B10A3:86 [AFS (ADAPTIVE FRONT LIGHTING SYSTEM)]

id0902g9934400

DESCRIPTION

Swivel actuator (LH) signal malfunction
DETECTION CONDITION
•  AFS control module detects the swivel actuator (LH) signal malfunction when the ignition is ON.
POSSIBLE CAUSE
•  Poor installation of discharge headlight connector
•  Swivel actuator (LH) malfunction
•  AFS control module malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
VERIFY THE DISCHARGE HEADLIGHT CONNECTOR INSTALLATION CONDITION
•  Remove the cover.
•  Is the discharge headlight connector installed in the correct position?
Yes
Go to the next step.
No
Install the discharge headlight connector in the correct position, then go to the next step.
(See HEADLIGHT BULB REMOVAL/INSTALLATION.)
2
VERIFY SWIVEL ACTUATOR (LH) MALFUNCTION
•  Clear the DTC from the AFS control module using the M-MDS.
•  Perform the DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the front combination light (LH), then go to the next step.
(See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)
No
Go to Step 4.
3
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC from the AFS control module using the M-MDS.
•  Perform the DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the AFS control module, then go to the next step.
(See AFS (ADAPTIVE FRONT LIGHTING SYSTEM) CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
4
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [AFS (ADAPTIVE FRONT LIGHTING SYSTEM)].)
No
DTC troubleshooting completed.