REAR DRAIN HOSE INSTALLATION

id091500801600

Caution

•  If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the rear drain hose. Fix any problem if found.

1.  Apply soapy water to the rear drain hose inserting area.

2.  Insert one end (the wider side) of the rear drain hose into the sunroof frame.

3.  Install the rear drain hose to the clips parallel to the pillar and free of slack.

4.  Insert the rear drain hose joint into the rear pillar inner hole.

5.  Install the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

6.  Install the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION.)

7.  Install the headliner. (See HEADLINER REMOVAL/INSTALLATION.)

8.  Install the assist handle. (See ASSIST HANDLE REMOVAL/INSTALLATION.)

9.  Install the sunvisors. (See SUNVISOR REMOVAL/INSTALLATION.)

10.  Connect the rain sensor connector. (Vehicles with rain sensor)

11.  Connect the dimming mirror connector. (Vehicles with dimming mirror)

12.  Install the following parts:

(1)  Trunk side upper trim (5HB, wagon) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(2)  D-pillar trims (wagon) (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

(3)  C-pillar trims (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(4)  Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(5)  B-pillar upper trims (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)

(6)  B-pillar lower trims (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)

(7)  Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(8)  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(9)  Upper anchor of the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)

(10)  A-pillar trims (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(11)  Sunroof seaming welt

13.  Install the seaming welt.

14.  Connect the negative battery cable.