ANTENNA FEEDER NO.2 INSPECTION

id092000812500

4SD

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  A-pillar trim (RH) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(2)  Rear scuff plate (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(3)  Rear seat cushion (RH) (See REAR SEAT CUSHION REMOVAL/INSTALLATION [4SD].)

(4)  Rear side seat back (RH) (See REAR SIDE SEAT BACK REMOVAL/INSTALLATION.)

(5)  Tire house trim (RH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(6)  C-pillar trim (RH) (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

3.  Disconnect antenna feeder No.1.

am6zzw00002012

4.  Disconnect antenna feeder No.3.

am6zzw00001984

5.  Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.

am6zzw00006816

•  If not as indicated in the table, replace antenna feeder No.2.

am6zzw00006817

5HB

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  A-pillar trim (RH) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(2)  Rear scuff plate (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(3)  Tire house trim (RH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(4)  Trunk side upper trim (RH) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(5)  Trunk side trim (RH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(6)  Lower anchor of the rear seat belt installation bolt (RH) (See REAR SEAT BELT REMOVAL/INSTALLATION [5HB, WGN].)

(7)  C-pillar trim (RH) (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

3.  Disconnect antenna feeder No.1.

am6zzw00002012

4.  Disconnect antenna feeder No.3.

am6zzw00002013

5.  Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.

am6zzw00006095

•  If not as indicated in the table, replace antenna feeder No.2.

am6zzw00006818

WGN

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  A-pillar trim (RH) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(2)  Rear scuff plate (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(3)  Tire house trim (RH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(4)  Trunk side upper trim (RH) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(5)  D-pillar trim (RH) (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

3.  Disconnect the antenna feeder No.1.

am6zzw00002012

4.  Disconnect the antenna feeder No.2.

am6zzw00003217

5.  Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.

am6zzw00006095

•  If not as indicated in the table, replace antenna feeder No.2.

am6zzw00006818