SOLENOID VALVE REMOVAL/INSTALLATION (SECONDARY CONTROL VALVE BODY) [FS5A-EL]


id051721808000

Caution
•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.

1.  Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

2.  Disconnect the negative battery cable.

3.  Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [L8, LF, L5].)

4.  Remove the aerodynamic under cover NO.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

5.  Drain the ATF into a separate suitable container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL].)

6.  Remove the EPS control module. (See EPS CONTROL MODULE REMOVAL/INSTALLATION.)

7.  Remove the oil cover. (See SECONDARY CONTROL VALVE BODY REMOVAL [FS5A-EL].)

8.  Remove the secondary control valve body. (See SECONDARY CONTROL VALVE BODY REMOVAL [FS5A-EL].)

9.  Remove the bracket.

am6zzw00000321

10.  Remove the solenoid valve(s).

am6zzw00002895

11.  Apply ATF to a new O‐ring and install it on the solenoid valve.

12.  Install the solenoid valve in the secondary control valve body.

Tightening torque
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}

13.  Install the secondary control valve body. (SeeSECONDARY CONTROL VALVE BODY REMOVAL [FS5A-EL].)

14.  Install the oil cover. (SeeSECONDARY CONTROL VALVE BODY REMOVAL [FS5A-EL].)

15.  Install the EPS control module. (SeeEPS CONTROL MODULE REMOVAL/INSTALLATION.)

16.  Install the battery and battery tray. (SeeBATTERY REMOVAL/INSTALLATION [L8, LF, L5].)

17.  Add ATF. (SeeAUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL].)

18.  Install the aerodynamic under cover NO.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

19.  Connect the negative battery cable.

20.  Perform the mechanical system test. (SeeMECHANICAL SYSTEM TEST [FS5A-EL].)