VENTILATOR GRILLE REMOVAL/INSTALLATION
id091700804600
Center
1. Disconnect the negative battery cable.
2. Remove the center panel upper. (See CENTER PANEL UPPER REMOVAL/INSTALLATION)
3. Remove the screw.
4. Remove the center ventilator grille from the center panel upper.
5. Install in the reverse order of removal.
Driver-side
1. Disconnect the negative battery cable.
2. Remove the following part:
- (1) Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (2) Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
- (3) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
- (4) Drive-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (5) Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
- (6) Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
- (7) Meter hood (See METER HOOD REMOVAL/INSTALLATION.)
3. Rotate the ventilator grille to the notch in the direction of the arrow (1) shown in the figure and pull it in the direction of the arrow (2) to remove it.
4. Install in the reverse order of removal.
Passenger-side
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
- (2) Passenger-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (3) Grove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
- (4) Side panel (See SIDE PANEL REMOVAL/INSTALLATION.)
- (5) Center panel upper (See CENTER PANEL UPPER REMOVAL/INSTALLATION.)
- (6) Audio unit (Vehicles with audio system) (See AUDIO UNIT REMOVAL/INSTALLATION.)
- (7) Car-navigation unit (Vehicles with car-navigation system) (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
- (8) Passenger-side air bag module (See PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)
3. Rotate the ventilator grille to the notch in the direction of the arrow (1) shown in the figure and pull it in the direction of the arrow (2) to remove it.
4. Install in the reverse order of removal.
