ANTENNA FEEDER NO.1 INSPECTION


id092000812400

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Shift lever knob (MT) (See TRANSMISSION REMOVAL/INSTALLATION [P66M-D].)
(2)  Shift knob (AT) (See SELECTOR LEVER REMOVAL/INSTALLATION.)
(3)  Upper panel (See CONSOLE REMOVAL/INSTALLATION.)
(4)  Ashtray panel (See CONSOLE REMOVAL/INSTALLATION.)
(5)  Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
(6)  Center panel unit (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)
(7)  Inner scuff plate (LH) (See INNER SCUFF PLATE REMOVAL/INSTALLATION.)
(8)  Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

3.  Verify that the continuity is as indicated in the table.

ar8jjw00001920

•  If not as indicated in the table, replace the antenna feeder No.1.
ar8uuw00001029