Operation CHARM: Car repair manuals for everyone.
Home >> Volkswagen >> 2006 >> Rabbit (1K1) L5-2.5L (BGP) >> Repair and Diagnosis >> Power and Ground Distribution >> Relay Box >> Service and Repair >> Relay Carrier At Vehicle Electrical System Control Module, At Left Instrument Panel, Removing and Installing
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Relay Carrier At Vehicle Electrical System Control Module, At Left Instrument Panel, Removing and Installing



Relay Carrier At Vehicle Electrical System Control Module, At Left Instrument Panel, Removing And Installing

NOTE:
- Vehicle Electrical System Control Module J519 and relay carrier at vehicle electrical system control module, at left instrument panel, are one component and cannot be separated.
- If Vehicle Electrical System Control Module J519 is to be replaced, the work procedure to read out the codes stored in the module must always be performed.

Removing:
- Switch off ignition, switch off all electrical consumers and remove ignition key.
- Remove cover in drivers side footwell.
- Remove storage compartment on drivers side.







- Slide securing latch -1- of harness connector of relay carrier at vehicle electrical system control module, at left instrument panel, in - direction of arrow A -.
- Slide Vehicle Electrical System Control Module J519 connector securing latch -2- in - direction of arrow B -.

NOTE: Harness connectors of Vehicle Electrical System Control Module J519 and of relay carrier at vehicle electrical system control module, at left instrument panel, can only be disconnected if securing latch was brought into position "OPEN" beforehand.

- Disconnect all harness connectors of Vehicle Electrical System Control Module J519 and of relay carrier at vehicle electrical system control module, at left instrument panel.

NOTE: The number of electrical connections depends on vehicle equipment level and market version.

- Clip Vehicle Electrical System Control Module J519 and relay carrier at vehicle electrical system control module, at left instrument panel, out of locking devices -arrows C-.
- Pull Vehicle Electrical System Control Module J519 and relay carrier at vehicle electrical system control module, at left instrument panel, downward and out of bracket in opposite direction of travel.

Installing:
Install in reverse order of removal, noting the following:

NOTE: Connector lock can only be brought into position "CLOSE" when all connectors are "correctly" connected.
pro multis · About Operation CHARM