Headlamp Range Control Module

Headlamp Range Control Module

Special tools, testers and auxiliary items required

• Trim removal wedge (VAS 3409)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( trim removal wedge (VAS 3409), screwdriver) will be positioned, using commercially available adhesive tape.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove side cover - 1 - of instrument panel, do this by inserting trim removal wedge (VAS 3409) or a screwdriver into recess - 2 - and pry off cover - 1 - in - direction of arrow -.





- Disengage securing bracket - 1 - in - direction of arrow - and disconnect harness connector - 2 - from Headlamp Range Control Module (J431).





- Remove mounting bolt - arrow - and remove Headlamp Range Control Module (J431) - 1 - from bracket - 2 -.





Installing

Install in reverse order of removal, noting the following:

- Insert Headlamp Range Control Module (J431) - 3 - with retaining clip - 2 - in bracket - 1 -.





- Engage harness connector - 1 - by pressing securing bracket - 2 - in - direction of arrow -.





• After installing a new Headlamp Range Control Module (J431), it must be coded. Refer to => [ Headlamp Range Control Module, Coding ] Testing and Inspection.