NOT P POSITION SWITCH INSPECTION

id051800300000

Note
•  The not P position switch is built into the selector lever component.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)
(2)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
(3)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
(4)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
(5)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

3.  Disconnect the selector lever component connector.

ac8wzw00003026

4.  Verify that the continuity between selector lever component terminals B and G.

adejjw00010793

•  If not as verified, replace the selector lever component. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

Not P position switch specification

Test condition

Continuity
Selector lever is in the P position.
No continuity
Selector lever is not in the P position.
Continuity