THEFT-DETERRENT HORN INSPECTION

id091400004900

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts.

(1)  Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(3)  Trunk side pocket(RH) (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)

(4)  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(5)  Theft-deterrent horn (See THEFT-DETERRENT HORN REMOVAL/INSTALLATION.)

3.  Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the figure, and then verify that the horn sounds.

ac9uuw00009430

•  If the horn does not sound, replace the horn. (See THEFT-DETERRENT HORN REMOVAL/INSTALLATION.)