KEYLESS RECEIVER INSPECTION

id091400514400

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2. Remove the following parts:

(1) Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(2) Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(3) Trunk side pocket (RH) (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)

(4) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

3. Remove the keyless receiver with the connector still connected. (See KEYLESS RECEIVER REMOVAL/INSTALLATION.)

4. Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).

• If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).

― If the system does not operate normally even though the parts under Inspection Item(s) do not have any malfunction, replace the keyless receiver. (See KEYLESS RECEIVER REMOVAL/INSTALLATION.)

Terminal Voltage Table (Reference)

ac9uuw00009439

Terminal

Signal name

Connected to

Measurement conditions

Voltage (V)

Inspection item(s)

A

Power supply

Start stop unit

Under any condition

Approx. 5

•  Start stop unit

―  Terminal 2Q

•  Related wiring harness

B

DATA

Start stop unit

Because this terminal is for communication, determination using terminal voltage inspection is not possible.

C

—

—

—

—

—

D

GND

Body ground

Under any condition

1.0 or less

Ground

Terminal	Signal name	Connected to	Measurement conditions	Voltage (V)	Inspection item(s)
A	Power supply	Start stop unit	Under any condition	Approx. 5	• Start stop unit ― Terminal 2Q • Related wiring harness
B	DATA	Start stop unit	Because this terminal is for communication, determination using terminal voltage inspection is not possible.
C	—	—	—	—	—
D	GND	Body ground	Under any condition	1.0 or less	Ground