LICENSE PLATE LIGHT INSPECTION

id091800821100

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

(2)  Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Liftgate recess (See LIFTGATE RECESS REMOVAL/INSTALLATION.)

(4)  Power liftgate (PLG) rear switch (with power liftgate (PLG) system) (See POWER LIFTGATE (PLG) REAR SWITCH REMOVAL/INSTALLATION.)

(5)  Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)

3.  Remove the license plate light. (See LICENSE PLATE LIGHT REMOVAL/INSTALLATION.)

4.  Apply battery voltage to license plate light terminal A, and connect terminal B to ground.

5.  Verify that the license plate light illuminates.

ac8jjw00002732

•  If the license plate light does not illuminate, replace the license plate light. (See LICENSE PLATE LIGHT REMOVAL/INSTALLATION.)