VENTILATOR GRILLE REMOVAL/INSTALLATION

id091700454100

L.H.D.

1.  Partially peel back the seaming welt.

2.  Remove the following parts:

(1)  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

(4)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].)

(5)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(6)  Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(7)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(8)  Lowre panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(9)  Side panel (See SIDE PANEL REMOVAL/INSTALLATION.)

3.  Rotate the ventilator grille to the notch in the direction of the arrow (1) shown in the figure and pull it in the direction of the arrow (2) to remove it.

am2zzw00006260

4.  Install in the reverse order of removal.

R.H.D.

1.  Remove the side panel. (See SIDE PANEL REMOVAL/INSTALLATION)

2.  Rotate the ventilator grille to the notch in the direction of the arrow (1) shown in the figure and pull it in the direction of the arrow (2) to remove it.

am2zzw00006260

3.  Install in the reverse order of removal.