SHOCK ABSORBING PAD REMOVAL/INSTALLATION [(E)]
id0917004533x2
1. Position the front seat back to the fully reclined position and slide the front seat to its furthest rearward position.
2. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(E)].)
3. Remove the following parts:
- (1) Front map light (See FRONT MAP LIGHT REMOVAL/INSTALLATION [(E)].)
-
- (2) Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)
-
- (3) Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)
-
- (4) A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
-
- (5) Front seat belt lower anchor (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
-
- (6) B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
-
- (7) Rear package tray (5HB) (See REAR PACKAGE TRAY REMOVAL/INSTALLATION.)
-
- (8) Trunk side upper trim (5HB) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)
-
- (9) C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
-
- (10) Shift lever knob (MTX) (See SHIFT LEVER REMOVAL/INSTALLATION [C66M-R].) (See SHIFT LEVER REMOVAL/INSTALLATION [F66M-R].)
-
- (11) Selector lever knob (ATX) (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)
-
- (12) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
-
- (13) Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
-
- (14) Cup holder (See CUP HOLDER REMOVAL/INSTALLATION.)
-
- (15) Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
-
- (16) Rear console (See REAR CONSOLE REMOVAL/INSTALLATION [(E)].)
-
- (17) Rear vent duct No.2 (with rear vent duct) (See REAR VENT DUCT REMOVAL/INSTALLATION.)
-
- (18) Rear vent duct No.1 (with rear vent duct) (See REAR VENT DUCT REMOVAL/INSTALLATION.)
-
- (19) Rear console bracket No.1 (See REAR CONSOLE REMOVAL/INSTALLATION [(E)].)
-
- (20) Headliner (See HEADLINER REMOVAL/INSTALLATION [(E)].)
-
- (21) Curtain air bag module (See CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].)
-
4. Remove the clips.
5. Remove the shock absorbing pad in the direction of the arrows shown in the figure.
6. Install in the reverse order of removal.
