PARKING BRAKE REMOVAL/INSTALLATION [CABLE SPLIT TYPE]

id0412008002d1

Note
•  The removal/installation procedure for the parking brake component part differs according to the part shipped from the factory. If the front parking brake cable and rear parking brake cable have been shipped from the factory as a single component, perform the parking brake removal/installation procedure referring to the integrated cable type. (See PARKING BRAKE REMOVAL/INSTALLATION [INTEGRATED CABLE TYPE].)

1.  To remove the parking brake lever and front parking brake cable, remove the console. (See CONSOLE REMOVAL/INSTALLATION.)

2.  If the front and rear parking brake cable is to be removed, perform the following procedure:

1.  Remove the tunnel member. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [ZJ, ZY, Z6].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF, L3].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [L3 Turbo].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
2.  Remove the installation nuts for the silencer, main silencer or the presilencer. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [ZJ, ZY, Z6].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF, L3].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [L3 Turbo].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
3.  Disconnect the hanger rubber from the silencer, main silencer or presilencer, except for that installed to the vehicle front and rear ends, and suspend either the silencer, main silencer or presilencer using a rope.
aaxjjw00004100
4.  Remove the heat insulator.
5.  Move the rear heat insulator to a location that does not obstruct the servicing procedure.

3.  Remove in the order indicated in the table.

4.  Install in the reverse order of removal.

5.  After installation, inspect the parking brake lever stroke. (See PARKING BRAKE LEVER INSPECTION.)

am3zzw00004842

1
Parking brake switch connector
2
Adjusting nut
3
Parking brake lever
4
Front parking brake cable
(See Front Parking Brake Cable Installation Note.)
5
Brake drum
6
Hold spring
7
Leading shoe
8
Trailing shoe
9
End cable
(See End Cable Removal Note.)
(See End Cable Installation Note.)
10
Shoe return spring
11
Adjuster
(See REAR BRAKE (DRUM) REMOVAL/INSTALLATION.)
12
Rear parking brake cable
(See Rear Parking Brake Cable Installation Note.)


End Cable Removal Note

1.  Disconnect the rear parking brake cable indicated in the figure, remove the end cable.

am3zzw00003189


Rear Parking Brake Cable Installation Note

1.  Install the rear parking brake cable to the parking brake brackets on the vehicle so that rear parking brake cable on the right side of the vehicle runs on top of the rear parking brake cable on the left side of the vehicle as shown in the figure.

am3zzw00004840

2.  Pass the rear parking brake cable through the inside of the vehicle from the rear ABS wheel speed sensor wiring harness (disc-brake type).

am3zzw00003190

3.  Install the rear parking brake cable clips to the vehicle being careful of the installation direction.


End Cable Installation Note

1.  Install the rear parking brake cable to the end cable.

2.  Make sure that the end cable tab is caught correctly.

am3zzw00003191


Front Parking Brake Cable Installation Note

1.  Apply silicone grease to the grommet areas of the front parking brake cable.

2.  Install the front parking brake cable with the mark on the equalizer facing toward the vehicle downside.

am3zzw00003192