DTC B10A5:86 [BCM]

id0902f5413000

DESCRIPTION

Error signal from theft-deterrent siren
DETECTION CONDITION
•  BCM receives the error signal from theft-deterrent siren for 2.5 s or more.
POSSIBLE CAUSE
•  Theft-deterrent siren connector or terminals malfunction
•  BCM connector or terminals malfunction
•  Short to ground in wiring harness between theft-deterrent siren terminal B and BCM terminal 6U
•  Short to power supply in wiring harness between theft-deterrent siren terminal B and BCM terminal 6U
•  Theft-deterrent siren malfunction
•  BCM malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
CONFIRM BCM DTC
•  Clear the DTC using the M-MDS.
•  Switch the ignition to ON and wait for 2.5 s or more.
•  Perform the BCM DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Go to the next step.
No
Go to Step 8.
2
INSPECT THEFT-DETERRENT SIREN CONNECTOR AND TERMINALS
•  Switch the ignition to off.
•  Disconnect the negative battery cable.
•  Disconnect the theft-deterrent siren connector.
•  Inspect the connector and terminals (corrosion, damage, pin disconnection).
•  Is there any malfunction?
Yes
Repair or replace the connector or terminals, then go to Step 7.
No
Go to the next step.
3
INSPECT BCM CONNECTOR AND TERMINALS
•  Disconnect the BCM connector.
•  Inspect the connector and terminals (corrosion, damage, pin disconnection).
•  Is there any malfunction?
Yes
Repair or replace the connector or terminals, then go to Step 7.
No
Go to the next step.
4
INSPECT THEFT-DETERRENT SIREN CIRCUIT FOR SHORT TO GROUND
•  Verify that the theft-deterrent siren and BCM connectors are disconnected.
•  Inspect for continuity between theft-deterrent siren terminal B (wiring harness-side) and body ground.
•  Is there continuity?
Yes
Repair or replace the wiring harness for a possible short to ground, then go to Step 7.
No
Go to the next step.
5
INSPECT THEFT-DETERRENT SIREN CIRCUIT FOR SHORT TO POWER SUPPLY
•  Verify that the theft-deterrent siren and BCM connectors are disconnected.
•  Reconnect the negative battery cable.
•  Switch the ignition to ON.
•  Measure the voltage at the theft-deterrent siren terminal B (wiring harness-side).
•  Is there any voltage?
Yes
Repair or replace the wiring harness for a possible short to power supply, then go to Step 7.
No
Go to the next step.
6
INSPECT THEFT-DETERRENT SIREN
•  Inspect the theft-deterrent siren.
•  Is there any malfunction?
Yes
Replace the theft-deterrent siren, then go to the next step.
(See THEFT-DETERRENT SIREN AND TILT SENSOR REMOVAL/INSTALLATION.)
No
Go to the next step.
7
VERIFY TROUBLESHOOTING COMPLETED
•  Make sure to reconnect all disconnected connectors.
•  Reconnect the negative battery cable.
•  Clear the DTC using the M-MDS.
•  Switch the ignition to ON and wait for 2.5 s or more.
•  Perform the BCM DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the BCM.
Go to the next step.
No
Go to the next step.
8
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [BCM].)
No
DTC troubleshooting completed.