STARTER CUT RELAY REMOVAL/INSTALLATION [MTX]

id0921004186a2

Advanced Keyless Entry And Push Button Start System Only

1.  Disconnect the negative battery cable.

(See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)

2.  Remove the following parts:

1.  Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

2.  Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

3.  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

4.  Console (See CONSOLE REMOVAL/INSTALLATION.)

3.  Set the bonnet release lever out of the way. (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

4.  Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION.)

5.  Disconnect the connector.

am3uuw00005080

6.  Remove the nut.

am3uuw00005081

7.  Remove the starter cut relay.

8.  Install in the reverse order of removal.