NO.31 M RANGE POSITION INDICATOR LIGHT DOES NOT ILLUMINATE IN M RANGE/M RANGE POSITION INDICATOR LIGHT ILLUMINATE IN D RANGE [FS5A-EL]


id050308813300

31

M range position indicator light dose not illuminate in M range/M range position indicator light illuminate in D range

DESCRIPTION
•  M range position indicator light in instrument cluster dose not illuminate in M range or M range position indicator light in instrument cluster in D range with ignition at ON.
POSSIBLE CAUSE
•  M range switch (built-in selector lever component) or related wiring harness malfunction
•  Instrument cluster malfunction
Note
•  Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL].) (See BASIC INSPECTION [FS5A-EL].)

Diagnostic procedure

STEP

INSPECTION

ACTION

1
Inspect the value at the following TCM PID using the M-MDS.
•  MNL SW
Is the PID value normal?
Yes
Go to Step 3.
No
Go to the next step.
2
Inspect the M range switch.
Is the M range switch normal?
Yes
Inspect for short to ground in wiring harness between TCM terminal 2B and selector lever component terminal A.
Repair or replace any malfunctioning parts according to the inspection result.
No
Replace the M range switch.
3
Inspect the instrument cluster.
Is the instrument cluster normal?
Yes
Go to the next step.
No
Replace the instrument cluster.
4
•  Verify the test results.
―  If normal, return to the diagnostic index to service any additional symptoms.
―  If the malfunction remains, inspect the related Service Information and perform repair or diagnosis.
•  If the vehicle is repaired, troubleshooting is completed.
•  If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.