REAR HEAT DUCT COMPONENT REMOVAL/INSTALLATION
id071100802800
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Front seat (See FRONT SEAT REMOVAL/INSTALLATION.)
- (2) Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (3) Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
- (4) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
- (5) Shift lever knob (See MANUAL TRANSAXLE SHIFT MECHANISM LOCATION INDEX [G35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM LOCATION INDEX [G66M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM LOCATION INDEX [A26M-R].)
- (6) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
- (7) Center panel lower (See CENTER PANEL LOWER REMOVAL/INSTALLATION.)
- (8) Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (9) Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)
3. Turn the floor covering over. (See FLOOR COVERING REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
|
1
|
Fastener
|
|
2
|
Heat duct (RH)
|
|
3
|
Heat duct (LH)
|
5. Install in the reverse order of removal.
