PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
id081000801900
-
Warning
-
-
Note
-
• When replacing the passenger-side air bag module after the deployment, replace it together with the mid-wiring harness.
• When installing the mid-wiring harness, install it along the vehicle wiring harness using bands or tape.
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the following parts:
- (1) Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
- (2) Center panel upper (See CENTER PANEL UPPER REMOVAL/INSTALLATION.)
- (3) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
- (4) Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (5) Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (6) Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
- (7) Side panel (See SIDE PANEL REMOVAL/INSTALLATION.)
- (8) Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [A26M-R].)
- (9) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
- (10) Center panel lower (See CENTER PANEL LOWER REMOVAL/INSTALLATION.)
- (11) Audio unit (Vehicles with audio system) (See AUDIO UNIT REMOVAL/INSTALLATION.)
- (12) Dashboard upper garnish (See DASHBOARD UPPER GARNISH REMOVAL/INSTALLATION.)
4. Remove the screws.
5. Pull the passenger-side air bag module in the direction of arrow (1) and detach the hook (2) from the Dashboard upper garnish.
6. Rotate the passenger-side air bag module (3) and remove it (4).
7. Install in the reverse order of removal.
8. Switch the ignition to ON.
9. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
• If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. (See
FLOWCHART.)