GPS ANTENNA FEEDER INSPECTION
id092000802100
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Front scuff plate (driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (2) Front side trim (driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
- (3) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
- (4) Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (5) Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)
- (6) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
- (7) Center panel lower (See CENTER PANEL LOWER REMOVAL/INSTALLATION.)
- (8) Center panel upper (See CENTER PANEL UPPER REMOVAL/INSTALLATION.)
- (9) Climate control unit (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER].) (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].)
- (10) Car-navigation unit (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
- (11) Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
- (12) Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
- (13) Meter hood (See METER HOOD REMOVAL/INSTALLATION.)
3. Verify that the continuity is as indicated in the table.
-
• If not as indicated in the table, replace the GPS antenna feeder.
