Refer to "54.Brake Control 4A.Troubleshooting(ABS/ESC) diagnostic System Check - Brake Controls".
1) Connect the scan tool.
2) Clear the DTC with a scan tool.
3) Turn OFF the ignition switch.
4) Turn ON the ignition switch.
5) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to Hill descent control switch inspection.
No
Go to Intermittent conditions of brake.
Refer to "205.Brakes 18D.Symptom intermittent conditions of brake".
1) Inspect the hill descent control switch. Is the result normal?
Refer to "9.Body, Cab, Accessories 9C.Electrical Control, Entertainment hill descent control switch inspection".
Yes
=>Go to Hill descent control switch wire harness and connector inspection.
No
Replace the hill descent control switch.
Refer to "9.Body, Cab, Accessories 9C.Electrical Control, Entertainment hill descent control switch removal".
Refer to "9.Body, Cab, Accessories 9C.Electrical Control, Entertainment hill descent control switch installation".
1) Turn OFF the ignition switch.
2) Disconnect the EHCU harness connector (C13) and hill descent control switch harness connector (C83).
3) Inspect the wire harnesses and connectors for the following. Is the result normal?
Wire harness to be inspected
Inspection items
Refer to "RHD Electronic Stability Control" in the ETM (wiring diagram). (Open using the ETM viewer.).
Refer to "LHD Electronic Stability Control" in the ETM (wiring diagram). (Open using the ETM viewer.).
Yes
No
Repair the circuit as necessary.
Note
Refer to "4.Brakes 4Z.Brake Electrical Control EHCU removal".
Refer to "4.Brakes 4Z.Brake Electrical Control EHCU installation".
Refer to "4.Brakes 4Z.Brake Electrical Control EHCU setting".
Procedure completion
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool.