Refer to "75.Driver Assistance System 10W.Troubleshooting(Stereo Camera) diagnostic system check-stereo camera".
1) Connect the scan tool.
2) Turn ON the ignition switch.
3) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to Body CAN communication circuit inspection and Chassis CAN communication circuit inspection.
No
Go to Intermittent conditions of stereo camera.
Refer to "233.Driver Assistance System 46D.Symptom(Stereo Camera) intermittent conditions of stereo camera".
1) Perform the Body CAN communication circuit inspection and Chassis CAN communication circuit inspection.
Refer to "64.Body Control 10I.Troubleshooting(Central GateWay) body CAN communication circuit inspection".
Refer to "64.Body Control 10I.Troubleshooting(Central GateWay) chassis CAN communication circuit inspection".
Procedure completion
=>Go to Current DTC follow-up check.
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to Stereo camera replacement.
No
Note
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera removal".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera installation".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera setting".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera writing".
Procedure completion
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool.